Working environment and operation process of grinding media production line

- Apr 20, 2019 -

1. When the grinding media production line is cleaning, its equipment is very easy to have dirt after cleaning for a long time. In the process of cleaning, it is not possible to use high pressure and high temperature water gun to wash, especially the electrical part, but it is not Wash it with water to avoid causing the appliance to burn out.


2. The selection and replacement of the oil in the grinding media production line requires attention to the nature of the fuel oil for the selection of fuel oil. The commonly used fuel oil is diesel oil, but it should be noted that the freezing point is higher than the diesel oil equivalent to the ambient temperature. Diesel fuels that are 5 degrees lower than the ambient temperature should be used. Diesel fuels such as -10#, -20#, -35# can be used. In the cleaning process, the fuel system needs to be completely cleaned up. At the same time of cleaning, it is necessary to check whether the oil pump is normal and eliminate the hidden troubles. The fuel system is also cleaned up so that the fuel oil can be used to keep up with the equipment when the equipment is started. For the replacement of lubricating oil or grease, it is necessary to pay attention to the use of lubricating oil by the equipment, and decide whether it needs to be replaced according to the amount of use.


3. During the operation of the grinding media production line, the components have different temperatures depending on the work content. There is a cooling system in the equipment. When cleaning, be careful not to precipitate the mud in the water tank in the cooling system. It should be removed in time, and the water temperature of the water tank should not be too high or too low. Antifreeze should be added to the water tank.


https://www.grindingballsmedia.com/